1. 在起動混凝土攪拌罐車之前，必須進行全面檢查。
1. Before starting the concrete mixing tank truck, a comprehensive inspection must be carried out.
2. 檢查汽車輪胎氣壓及磨損情況,按規定力矩緊固輪胎螺絲、輪胎氣壓補充到該車型規定值之內,根據磨損情況進行輪胎換位。
2. Check the tire pressure and wear condition, tighten the tire screw according to the specified torque, add the tire pressure to the specified value of the vehicle, and transpose the tire according to the wear condition.
3. 檢查發電機、空調、水泵及助力泵皮帶的松緊與老化情況。
3. Check the tightness and aging of the belt of generator, air conditioner, water pump and booster pump.
4. 檢查汽車前后車燈是否齊全(包括:大燈、視寬燈、轉向燈、剎車燈、倒車燈及霧燈)。
4. Check whether the front and rear lamps of the car are complete (including: headlamp, width lamp, steering lamp, brake lamp, reversing lamp and fog lamp).
5. 檢查發電機、空調、水泵及助力泵皮帶的松緊與老化情況。
5. Check the tightness and aging of the belt of generator, air conditioner, water pump and booster pump.
6. 檢查電瓶液面及玻璃清洗劑罐的液面。
6. Check the liquid level of the battery and the glass cleaner tank.
7. 檢查轉向助力油罐的油面是否符合規定,檢查系統各油管接口是否有滲油現象。
7. Check whether the oil level of the power steering oil tank meets the requirements, and check whether there is oil leakage at each oil pipe interface of the system.
8. 檢查制動器及離合器液面位置。
8. Check the liquid level of brake and clutch.
9. 檢查汽車?yán)鋮s液液面位置是否符合規定。

9. Check whether the vehicle coolant level meets the requirements.
10. 做好檢查后，規范行駛攪拌車。
10. After the inspection, drive the mixer in a standard way.
11. 混凝土攪拌罐車起動發動機后，應使攪拌筒在低速下轉動10分鐘左右，使液壓油溫升到20℃以上方可工作。
11. After starting the engine of the concrete mixing tank truck, the mixing drum should be turned at low speed for about 10 minutes to make the hydraulic oil temperature rise to above 20 ℃.
12. 攪拌車裝運攪拌好的混凝土?xí)r，攪拌筒轉速為210轉/分，在運輸過程中，平坦路面上攪拌筒轉速保證在2-3轉/分，行駛在側坡度大于50的路面，或左右晃動較大的路面時，應停止攪拌旋轉，待路況好轉后再恢復攪拌旋轉。
12. When the mixer truck transports the mixed concrete, the rotation speed of the mixing drum is 210 rpm. During transportation, the rotation speed of the mixing drum on the flat road should be 2-3 rpm. When driving on the road with side slope greater than 50 or the road with large left and right shaking, the mixing rotation should be stopped, and the mixing rotation should be resumed after the road condition improves.
13. 混凝土攪拌車運送混凝土的時間不能超過攪拌站規定的時間。運送混凝土途中，攪拌筒不得長時間停轉，以防混凝土產生離析現象。應時常觀察混凝土情況，發現異常及時通報調度室，申請作出處理。
13. The delivery time of concrete by concrete mixer truck shall not exceed the specified time of mixing plant. During the transportation of concrete, the mixing drum shall not stop for a long time to prevent concrete segregation. The concrete condition shall be observed from time to time, and any abnormality found shall be timely reported to the dispatching room for handling.
14. 攪拌車在排出混凝土之前，應使攪拌筒在10-12轉/分的轉速下轉動1分鐘，再進行排料。
14. Before discharging the concrete, the mixer should rotate the mixing drum at the speed of 10-12 rpm for 1 minute before discharging.

分享題目：混凝土攪拌罐車新手使用手冊
標題來源：http://www.js-pz168.com/hangye/zbljbc/n67355.html

聲明：本網站發布的內容（圖片、視頻和文字）以用戶投稿、用戶轉載內容為主，如果涉及侵權請盡快告知，我們將會在第一時間刪除。文章觀點不代表本網站立場，如需處理請聯系客服。電話：028-86922220；郵箱：631063699@qq.com。內容未經允許不得轉載，或轉載時需注明來源： 創新互聯